Laser marking of wooden door frames using a CO2 laser. Marked text was reorganized into 2 lines, so it could fit into a single working field of the recommended system (which is about 200x200mm). Other systems could be designed with a larger marking area. All four...
Laser cutting of the dashboard inset shapes was done at a low cutting speed to improve edge quality. The sample could be cut at a much faster speed but at the sacrifice of edge quality. A cycle time as low as 2.5 minutes could be performed. The cutting was done to the...
All three different wood parts were marked with the same parameters. Markings No.1 and No.2 (green numbers on the picture above) are different only in sizes and, therefore, in cycle times. Marking No.1 is done in 1.0 seconds, No.2 is done in 0.75 seconds. Sample...
Laser engraving / burning wood model and or serial numbers on Cabinet doors and drawer faces. 30 W @ 100% and 100-150 mm/sec. Various size cabinet doors were laser marked using the Fantom 30 Watt kit. Various species of wood marked well with a deep engraving. Little...
