All three different wood parts were marked with the same parameters. Markings No.1 and No.2 (green numbers on the picture above) are different only in sizes and, therefore, in cycle times. Marking No.1 is done in 1.0 seconds, No.2 is done in 0.75 seconds.
Sample Name: | Wood pieces | Working Distance: | 300mm |
Material: | Different wood | Power: | 100% (100W) |
Method Used: | Laser marking | Frequency: | CW-mode |
Depth: | Not measured | Speed: | 500mm/sec |
Laser Type: | 100W CW CO2 laser | Passes: | 1 |
Focal Length Lens: | 300mm | Cycle Time: | 1.0sec / 0.75sec |